Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10. If toast is too light or too dark, adjust the speed control.
Turn the knob to the right for lighter toasting. Turn the
knob to the left for darker toasting. For best results, use
day-old bread stored at room temperature.
Standby Function
11. During long periods of inactivity, the standby switch can be
used to decrease the unit to ¼ power. The switch is found
below the conveyor speed control knob and should be
switched to the right to activate this feature. This is done to
save power and energy during idle periods and extend the
life of the toaster's components. When full power is needed
once again, switch back to the left and allow 3 to 4 minutes
for unit to heat up again. The green indicator light will
illuminate when unit is ready to toast.
NOTE: Your conveyor toaster is equipped with an automatic shut
off feature. If unit shuts off automatically, immediately unplug the
toaster and let cool completely. Make sure the fan intake area is
clear and that there is ample space around the unit so that it does
not overheat (2 inches). Plug the unit back in and begin toasting.
CTS1000B
Initial Preparation
1. Follow instructions 1 through 3 in previous section.
2. Turn the unit to the desired function by twisting the function
knob located at the bottom of the control panel. The red
POWER ON indicator light will illuminate.
3. When conveyor toaster is ready for toasting, the green
READY/HOT indicator light will illuminate. This should take
approximately 5 minutes.
4. Turn the conveyor speed control knob to set the desired
toasting speed, 1 being the fastest speed and 9 being the
slowest.
5. Turn the power control to the desired setting, 1 being the
lightest setting and 9 being the darkest setting.
6. The darkness of your toast/bagel will depend on how hot
and how fast you select your controls.
7. When selecting the bagel function, only the bottom elements
will operate.
8
Tabla de contenido
