Service Mode, English - Bang & Olufsen BeoVision MX 4200 Manual Del Usuario

2.20

Service Mode, English

#8 Service Mode
Reading the error code
Access to Service Mode
To read an error code from the television you must access the Service Mode. Then
select MONITOR -> MONITOR INFORMATION. If the television has registered an
error, the error code will be shown in this menu under ERROR.
Select TV SETUP menu
Beo4: Press 0 0 GO within 3 seconds
SERVICE MENU
The STAND line is only shown if the TV is fi tted with motorized stand. The function
is described in the section on adjustments.
MONITOR SERVICE MENU
The PICTURE ADJUSTMENTS and GEOMETRY ADJUSTMENTS lines are described in
the section on adjustments.
MONITOR INFORMATION
- Software version numbers
The "STB SW 1.0" line is only shown if the M2 Processor, 1IC200 SDA6000, is
fi tted with set top box controller software.
The "STB TABLE 1.0" line shows the version of conversion of set top box remote
control codes into Beo4 codes.
- Type, item and serial numbers
- Theft protection status. Shows if the Master code is correctly entered (STORED/
NOT STORED)
- Option programming
- Latest fi ve TV errors
- Latest ML error
- Latest AVL error from the V.TAPE and AV sockets
OPTION SETTING
Option 0 = The IR receiver of the TV is disconnected.
Option 1 = The TV and the Audio system (BeoLink system) are placed in the same
room.
Option 2 = The TV and the Audio system (BeoLink system) are placed in different
rooms.
Option 5 = The TV and the Audio system (BeoLink system) are placed in the same
link room.
Option 6 = The TV is the only product in the link room.
ERROR:TV
The TV is able to detect certain types of error and display them on the screen.
The fi ve latest TV errors are shown as error codes and displayed with the month/
date (four digits) as provided by the system clock. The most recent error is
displayed at the top. As the TV has no hardware clock the displayed month/date
will not be correct, but can be used to see if more errors have occurred at the
same date.