Panasonic TY-WK103PV9 Instrucciones De Instalación página 4

Components
TY-WK103PV9 Wall-hanging bracket (Vertical mounting type)
Wall-hanging bracket
Base unit (L)
Points to note during installation
● The wall-hanging bracket is for use in installing the Plasma Display to a vertical wall for viewing
purposes. Do not use it for any type of installation other than vertical wall installation.
● In order to ensure correct, problem-free operation of the Plasma Display, do not install the Display in
any of the following places.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form
● When installing this wall-hanging bracket unit, use a fixing method appropriate to the type of wall.
● Use commercially available bolts with a nominal diameter of 12 mm (0.5 inches) that are suited to
the wall material (steel frame, concrete, etc.) you are fitting the bracket to.
● Fit so there is no contact between the attachment bolts or power cord and any metal inside the wall.
● Insert the power cord plug for the Plasma Display into a wall outlet which is close and easily
accessible.
● Provide adequate ventilation so that the temperature around the display does not rise above 40 °C
(104 °F). If there is insufficient movement of the air inside display, heat may build up inside the
display, and fire may result.
● Spread a soft blanket or cloth over the floor so that the plasma display and floor will not be marked
or scratched during the assembly and installation work.
● When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over
tightened.
● Take sufficient care to ensure safety around you when performing the assembly and installation work
or while moving about during the course of the work.
(1)
L
Wall-hanging bracket
Base unit (R) (1)
R
11