Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Mounting (Rack)
Mount your equipment in either a 2-post or 4-post rack or rack enclosure. The user must
determine the fitness of hardware and procedures before mounting. If hardware and
procedures are not suitable for your application, contact the manufacturer of your rack or
rack enclosure. The procedures described in this manual are for common rack and rack
enclosure types and may not be appropriate for all applications.
Note: The illustrations may differ from your model.
2-Post Mounting
Tripp Lite's 2-Post Rack-Mount Installation Kit (Model: 2POSTRMKITHD) is included with your
UPS system for rack-mounting purposes and convenience.
3U
X 8
1
Important: Illustrations show the most typical installation configuration; your model
may vary. Use only the pre-drilled screw holes to attach mounting brackets to the
sides of the unit. When installing battery packs into the rack, ensure that the weight
of the unit is evenly distributed.
4-Post Mounting
Tripp Lite's 4-Post Rack-Mount Installation Kit (Model: 4POSTRAILKIT) is also included with
your UPS system for rack-mounting purposes and convenience.
1
The included plastic pegs
temporarily support the empty rackmount
shelves
while you install the permanent
B
mounting hardware. Insert a peg near the
center of the front and rear bracket of
each shelf as shown. (Each front bracket
has 6 holes and each rear bracket has 3
holes.) The pegs will snap into place.
After installing the pegs, expand each shelf
to match the depth of your rack rails. The
pegs will fit through the square holes in
the rack rails to support the shelves. Refer
to the rack unit labels to confirm that the
shelves are level in all directions.
Note: The support ledge of each shelf must face
inward.
18-11-091-932968.indb 4
3U
X 4
2
will
A
1
4
X 4
3
B
A
A
12/12/2018 9:58:45 AM
Tabla de contenido
