Makita DMP180 Manual De Instrucciones página 6

Only for battery cartridges with the indicator
Indicator lamps Check button
Press the check button on the battery cartridge to indicate the remain-
ing battery capacity. The indicator lamps light up for a few seconds.
NOTE: Depending on the conditions of use and the
from the actual capacity.
The tool is equipped with a tool/battery protection system. This
tery life. The tool will automatically stop during operation if the
tool or battery is placed under one of the following conditions:
This protection works when the tool is operated in a manner
that causes it to draw an abnormally high current. In this situ-
tool to become overloaded. Then turn the tool on to restart.
This protection works and the light blinks when the tool
or battery is overheated. In this situation, let the tool and
battery cool before turning the tool on again.
This protection works when the remaining battery
capacity gets low. In this situation, remove the battery
from the tool and charge the battery.
WARNING:
1
CAUTION:
2
75% to 100%
50% to 75%
Main power switch
To turn on the tool, press the main power switch. To turn
25% to 50%
NOTE:
0% to 25%
To avoid unintentional start up, the main power switch
will automatically shut down when the switch trigger
Charge the
is not pulled for a certain period after the main power
battery.
switch is turned on.
The battery
may have
malfunctioned.
WARNING:
-
Switch trigger
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
6 ENGLISH
Otherwise, pulling the switch
1
-
1