Machine Storage; Available Accessories - Metabo Mega 600 D Manual De Instrucciones Original

Every 50 operating hours
Check air filter element (44) of com-
•
pressor pump, clean if necessary.
Check oil level (45) of compressor
•
pump, top up if necessary (46).
45
47
Drain the condensation water from
•
the pressure vessel into a container
(48). Tip or lift the unit if necessary.
A
The condensation water con-
tains oil residues. Dispose of the
condensation water in an environ-
mentally friendly manner to the ap-
propriate collection points!
– Clean the seal and thread of the
screw connection prior to reinser-
tion.
.
Clean air filter element (49) of filter/
•
regulator unit.
44
Drain condensate from filter/regula-
•
tor unit (50).
Check V-belt:
•
– Remove belt guard (51).
– Retension V-belt or replace, if
necessary.
– To adjust the V-belt tension, loos-
46
en the four screws at the motor
base and shift the motor.
– Tighten the screws at the motor
base again.
– Replace the belt guard.
Every 250 operating hours
48
Replace air intake filter element of
•
compressor pump.
Replace air filter element of filter/reg-
•
ulator unit.
49
50
51
ENGLISH
Every 500 operating hours
Drain oil from compressor pump
•
through the drain plug (47) and fill
with fresh oil.
A
Dispose of the waste oil envi-
ronmentally safe by taking it to a
proper collecting point!
Every 1000 operating hours
Have unit serviced by an authorized
•
service station. This will extent the
compressor's service life considera-
bly.
5.2

Machine storage

1. Switch unit OFF and unplug.
2. Release pressure from tank and all
connected air tools.
3. Store machine in such way that it
cannot be started by unauthorized
persons.
A
Caution!
Do not store machine unprotected
outdoors or in damp environment.
Do not lay machine on its side for
transportation or storing.
6.

Available Accessories

For special applications the following ac-
cessories are available at your specialist
dealer – see back cover for illustrations:
Sealing
A Air Caulking Gun KP 910
for commercially available cartridg-
es.
Stock-no. 090 101 0030
Sheet metal cutting
B Air Nibbler BN 540
extra small cutting radius; cuts steel
sheet up to 1.0 mm thickness.
Stock-no. 090 100 6784
Drilling
C Air Drill BM 310
especially handy tool for low-fatigue
working; right-hand rotation only.
Stock-no. 090 100 6725
Air Drill BM 500 (not shown)
•
with 3/8" keyless chuck, fully reversi-
ble with quick reverse feature.
Stock-no. 090 105 4533
15