Symbols On The Machine; Safety Devices; Operation; Mains Connection - Metabo Mega 600 D Manual De Instrucciones Original

Wear suitable work clothes. When work-
ing outdoors wearing of non-slip shoes
is recommended.
A
Hazard generated by electric
tool defects!
Do not make changes to the device.
Each change on parts which conduct
compressed air leads to invalidation of
the examination. Work on compressed
air devices must only be carried out by
specialists.
Keep electric tool and accessories in
good repair. Observe the maintenance
instructions.
Make sure that the device is maintained
and checked regularly.
Check the electric tool for any damage
each time prior to operation: Prior to fur-
ther use of the electric tool, safety devic-
es and protection devices must be care-
fully checked for flawless and proper
function. Check to see that all moving
parts work properly and do not jam. All
parts must be correctly installed and
meet all conditions necessary for the
proper operation of the electric tool.
Damaged protection devices or parts
must be repaired or replaced by a quali-
fied specialist. Have damaged switches
replaced by a service centre. Do not op-
erate electric tool if the switch can not
be turned ON or OFF.
Keep handles free of oil and grease.
3.3

Symbols on the machine

Data on the nameplate:
18
19
20
21
22
23
24
25
35 34 33
(18) Manufacturer
(19) Item no., version no., serial no.
(20) Machine designation
(21) Supply voltage / frequency
(22) Motor capacity P
(see also "Technical Specifica-
tions")
(23) Fuse protection / protection
class
(24) No. of cylinders
(25) Motor speed
(26) Country code
(27) Suction capacity
(28) Filling rate
(29) Speed compressor pump
(30) Max. pressure
(31) Pressure vessel volume
(32) Year of make
(33) CE-mark – This machine com-
plies with the EU Directives as
per declaration of conformity
(34) Waste disposal symbol – Device
can be disposed of by returning
it to the manufacturer.
(35) Weight
Maintenance sticker
3.4

Safety devices

Safety valve
26
27
28
29
30
31
The spring-loaded safety valve (36) is
32
incorporated into the pressure switch.
The safety valve opens if the max. per-
missible pressure is exceeded.
4.
1
4.1
B
Operate machine in dry environment
only.
Operate machine only on a power
source complying with the following
requirements:
– outlets properly installed, earthed
and tested;
– fuse protection in accordance
with the technical specifications.
Position power cable so it does not
interfere with the work and is not
damaged.
Always check to see that the machine
is switched OFF before plugging in.
B
Depending on the phase sequence,
the motor could turn in the wrong di-
rection. This can damage the ma-
chine. Therefore the direction of rota-
tion is to be checked every time the
machine is connected to the power
supply: The pulley of the compressor
pump must turn in the direction indi-
cated by the arrow on the belt guard.
If it turns in the wrong direction, two
phases must be interchanged in the
power cable plug:
1. Unplug.
2. Interchange phases with a screw-
driver as illustrated:
– Depress switch (37) slightly.
– and turn by 180 °.
36
3. Plug power cable in again.
Protect power cable from heat, ag-
gressive liquids and sharp edges.
Use only extension cables with suffi-
cient lead cross section (see "Techni-
cal Specifications").
Do not stop the machine by unplug-
ging, but switch OFF using the ON/
OFF switch.
Unplug after use.
ENGLISH

Operation

Mains connection

Danger! High Voltage
Check direction of rotation!
37
13