Motor Housing - Brentwood Appliances MG-400W Instrucciones De Operación Y Seguridad

PARTS:
1. Plunger / Part Storage
2. Die-Cast Hopper
3. Grinder/Feeder Head
4. Release Button

5. Motor Housing

6. Reverse Switch (REV)
7. On/Off Switch/Knob (I/O/II)
8. Body
9. Feeding Screw
10. Cutting Plate(Fine)
11. Cutting Blade
14. Sausage Horn
17. Kubbe / Cone Attachment
HOW TO USE
MINCING
See below figure 2
1. Insert the feeding screw into the grinder house, the plastic end first. Fit the
cutting blade unit onto the other end of feeding screw. (The cutting edge
should be placed at the front side). And then you can also fit the coarse or
fine cutting plate (Depending on the consistency you prefer). Make sure the
notch of the cutting plate fits into the opening on the cutter house. Fit the
screw ring on the grinder head by turning the screw ring clockwise until it is
properly fastened.
2. Fit the grinder head on the unit. The lugs on the motor unit must fit
precisely into the slots on the grinder head. Rotate the grinder head
counter-clockwise until hear a click. The grinder head is now locked into
position You can remove the grinder head by pressing the release button
on the appliance and turning the cutter housing clockwise.
3. Place the hopper/tray on the upright part of the grinder head.
12. Cutting Plate(Medium)
15. Kubbe Former
4
13. Screw Ring
16. Separator Ring