Tripp-Lite WorkWise WWSS1332W El Manual Del Propietario página 3

Assembly
1
Mount Bracket Arm
to wall.
1/4"
(6 mm)
WARNING
• When mounting on a wood stud wall, make sure that mounting screws are anchored
into the center of the studs. Use of a stud finder is highly recommended.
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or
"cinder block"), verify that the actual concrete thickness is at least 35 mm (1-3/8")
in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS! Be sure
to mount the wall mount with the included concrete anchors and anchor bolts onto
solid sections of the blocks. The solid sections can generally be found 25 mm (1")
toward the middle of the block from either end. An electric drill on a slow setting is
suggested to drill the hole rather than a hammer drill, so as to avoid breaking out
the back of the hole when entering a hollow section.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
17-09-137-93377A.indb 3
L
M
x3 x3
N
M
N L M
3
N
x3
60mm
(2.4")
ø 10mm
(ø 3 /8")
Mark the
1
exact location
of mounting
holes
Drill pilot
2
holes
XX
√
Screw the wall
mount onto
the wall
10/25/2017 3:05:48 PM