Tripp-Lite DMVWSC4570XUL El Manual Del Propietario página 7

Assembly
2b
Mount on Solid Brick or Concrete Block Wall
WARNING
• When installing wall mounts onto a concrete masonry unit (also known as a CMU or "cinder block"), verify that the actual
concrete thickness is at least 35 mm (1-3/8") in order to hold the concrete anchors. DO NOT DRILL INTO MORTAR JOINTS!
Be sure to mount the assembled wall-mount plate with the included concrete anchors, washers and anchor bolts onto solid
sections of the blocks.
The solid sections can generally be found 25 mm (1") toward the middle of the block from either end. An electric drill on a
slow setting is suggested to drill the hole rather than a hammer drill so as to avoid breaking out the back of the hole when
entering a hollow section.
• Installers must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
W-B
Using the ST6.3x55 screws (W-A), D6
W-A
washers (W-C) and concrete anchors (W-B),
attach wall plate assembly to the wall.
W-C
7
60 mm
(2.4 in.)
O / 10 mm
O / (3/8 in.)
Mark the exact Drill pilot
location of holes
mounting holes
Screw the
wall plate
onto the
wall