Tabla de contenido
- Once the charge is completed the red pilot light will turn off and
green pilot light will turn on.
- When the battery is charged disconnect the charger from the
mains supply.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all the product's packaging has been removed.
- Ensure that the voltage indicated on the rating label matches the
mains voltage before plugging in the appliance.
- Before using this product for the first time, it is important to make a
full charge of batteries.
INSERTING A BIT:
- To open the drill's chuck (1), whilst completely switched off, take
firm hold of the back part of the chuck and turn the front part of the
chuck counter clockwise.
- Insert the drill bit, screwdriver bit, or other tool/ accessory required
for the task, into the chuck. In order to obtain a secure fastening
of the bit, insert the bit as far as you can into the chuck. Take firm
hold of the back part of the chuck and turn the front part of the
chuck clockwise until it is firmly closed.
- In order to remove accessories from the chuck, follow the same
steps as indicated previously but in reverse order
SCREWING, DRILLING/UNSCREWING:
- To drill or screw, ALWAYS have the direction set to clockwise (CW).
- To unscrew, set the direction to counter clockwise (CCW).
- The appliance should not be in use when changing the screwing
direction.
HOW TO SELECT THE DIRECTION OF THE ROTATION
- Do not change the direction of the rotation whilst the tool motor is
in operation.
- The appliance has a selector (6), which allows the direction of
rotation to be changed.
Tabla de contenido
