Tabla de contenido
OBJ_BUCH-2118-001.book Page 15 Tuesday, November 19, 2013 4:26 PM
Declaration of Conformity
We declare under our sole responsibility that the product
described under "Tool Specifications" is in conformity with the
following standards or standardization documents:
EN 60745 according to the provisions of the directives
2009/125/EC (Regulation 1194/2012), 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Adolf Würth GmbH & Co.KG, PFW,
Reinhold-Würth-Straße 12-17
74653 Künzelsau, Germany
T. Klenk
A. Kräutle
General Manager
General Manager
Künzelsau: 19.11.2013
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Changing the position of the auxiliary
handle
Removing the battery
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 197.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
The declared vibration emission level represents the main
applications of the tool. However if the tool is used for differ-
ent applications, with different accessories or insertion tools or
is poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Mounting and Operation
Figure
1
2
Please observe
Page
198
198
15
Tabla de contenido
