Rel. Relative Mode (Only Main Display) - Promax MZ-505C Manual De Instrucciones

INSTRUCTION MANUAL. MZ-505C
8. Data Setting:
When using the character on the name plate to input data,
the previous setting will appear, and the place that waits to
be entered will flash. INPUT starts from the largest digit to
enter, the largest digit only 1, In that case the original setting
will flash. The original setting is 0, and the bottom part of
seven segments will flash. Press "1" is 1, press any keys is
0, press "ENTER" to exit without change. TOL Hi/Lo limits
setting without largest digit. There is no annunciator flashing
after entering 5 digits, In the mean time enters +/- symbols,
press "o" to change +/- symbols, press other keys to input +
symbol.
Caution: Press "ENTER", emit two beeps, the data store in
volatile storage. The data will store in nonvolatile storage
region whle the meter power off. In this mode the
automatic power-off feather is disabled.

4.10 REL. Relative mode (only Main display)

Press
is stored as a reference value, the display is zeroed and annunciator
Δ
" " is displayed. Press
For example: the displayed reading is 100.0, then press
[5] to store as a reference value, and the display become zero, to
store 100.0 as a standard reference value, if our input signal is 99,5
then the reading will be 99.5-100.0 that equals -0.5.
04/2015
[5] key to the Relative mode. The displayed reading
[5] key again to exit the Relative mode.
Page 23