L/C/R Function Button (Only Main Indicator); Q/ D/ R Function Button (Secondary Display); Hold. > 2Sec - Promax MZ-505C Manual De Instrucciones

INSTRUCTION MANUAL. MZ-505C

4.5 L/C/R Function button (only main indicator)

The key switch the measurement parameter in sequence
Q-D-R-Q..., the enunciator is indicated on LCD.
When the meter is turned on, it is set to the measurement
parameter selected that was in use when the meter was last turned
off.

4.6 Q/ D/ R FUNCTION BUTTON (secondary display)

The
sequence Q-D-R-Q..., the enunciator is indicated on LCD.
When the meter is turned on, it is set to the measurement
parameter selected that was in use when the meter was last turned
off.
4.7 HOLD. > 2sec.
Press the
enunciator is displayed.
When Hold mode is selected, the meer stops all further
measurements. Press
press this key for 2 seconds to exit the Backlit function.
After starting the Backlit for 1 minute, the Backlit function will exit
by itself.
04/2015
[9] key switch the measurement parameter in
[4] key to enter the data hold mode, the "HOLD"
[4] 2 seconds to start backlit function,
Page 19