Dip Switch Settings - Tripp-Lite B127F-1A1-MM-HH Manual Del Propietário

Standard Extender Kit Installation
Using an HDMI 2.0 cable (such as Tripp Lite P569-XXX-CERT or
5
P568-XXX-2A Series cables), connect the remote receiver unit's HDMI
port to a monitor.
Turn on the power to all of your connected displays (local and remote).
6
Connect the external power supply to the local transmitter unit and
7
plug it into an available wall outlet or (optional) a Tripp Lite Surge
Protector, Power Distribution Unit (PDU) or Uninterruptible Power
Supply (UPS). The POWER (green) LED on the local transmitter unit
will illuminate to indicate the unit is receiving power from the external
power supply. The POWER (green) LED on the remote receiver unit will
illuminate to indicate the units are receiving power from the external
power supply.
Turn on the power to the HDMI source. The OUTPUT (orange) LED on
8
the local unit will illuminate to indicate a signal has been received
from the source.
The (orange) LED will illuminate on both local transmitter and remote
9
receiver units to indicate a signal has been received from source to
display. The screen should now display on the connected monitor.

DIP Switch Settings

This extender kit provides one of the following functions via DIP switch
settings:
• USB 1.1 – One Micro-USB input at transmitter, dual USB-A outputs at
receiver
• Bi-Directional IR – Dual 3.5 mm jacks at both the transmitter and
receiver
• RS-232 – One 3-pin phoenix connector at both the transmitter and
receiver
-06-086-933974.indb 6
6
8/9/2019 9:36:13 AM