Operating Features - Urmet 1092/275H Guía Rápida

Adjusting ring for focuing
VARIFOCAL adjusting ring
8. After focusing and varifocal adjustment operations, tighten again the adjusting rings in order not to
change the adjustments just performed.
9. Use the menu button inside the minidome (see following paragraph)
10. Fix the protection dome to the minidome base, by screwing the three previously removed screws

OPERATING FEATURES

MENU setting
TO SELECT THE VIDEO OUTPUT
The 1092/275H camera may use 3 different video outputs, which are on the same BNC connector:

High-definition 1080P AHD (Analog High Definition) video output

CVBS standard interlaced video output

Video output in COMET mode
If pressing the menu access button to the RIGHT for a few seconds, you can select the AHD video output.
If pressing it for a few seconds to the LEFT, you can select the CVBS video output.
PAL e NTSC standards can be selected, besides from the OSD menu and for all video outputs, pressing
the menu access button to DOWN for a few seconds. The command works in toggle, selecting
alternatively PAL and NTSC.Pressing the button to UP it is also possible to select the video output to
720P (with reduction of the angle view).
DS1092-222A
Check pin of adjusting focus
ring
Check pin of VARIFOCAL
adjusting ring
UP
LEFT
SET
DOWN
RIGHT
7