DeWalt DW871 Manual De Instrucciones página 8

DW871/384765-01-00 2/10/00
Fence Angle Adjustment
Angle adjustment indicator is part of fence clamping system. Align
desired angle indicator line with edge of slot in base (see Figure 7).
For a more accurate square cut (Figure 7), disconnect power supply,
unlock fence, push arm down until wheel extends into base, place a
square against wheel, adjust fence against square, then lock fence
into position.
Switch
To start the tool, depress the trigger switch shown in Figure 8. To turn
the tool off, release the trigger switch. Keep hands and material from
wheel until it has coasted to a stop.
FIG. 7
ANGLE
ADJUSTMENT
INDICATOR
SLOT EDGE
FIG. 8
10:07 AM Page 8
WHEEL
SQUARE
TRIGGER SWITCH
Removal and Installation of Wheels
1. Be sure tool is disconnected from power supply.
2. Push in wheel lock lever (Figure 9) and rotate wheel by hand until
wheel lock lever engages slot in inside flange to lock wheel.
Loosen the bolt counterclockwise in the center of the abrasive
wheel with the 8 mm hex wrench found in the holder in the base.
Bolt has right hand thread.
3. Remove the bolt, washer, outside flange, and old wheel (Fig. 10).
4. Install the new abrasive wheel by reversing the above steps.
5. Do not over tighten bolt.
DO NOT MAKE ANY ADJUSTMENT WHILE THE WHEEL IS IN MOTION.
DO NOT MAKE ANY ADJUSTMENT WHILE CHOP SAW IS PLUGGED
INTO POWER SUPPLY.
WARNING: CHECK THE WORK SURFACE THAT THE CHOP
SAW RESTS ON WHEN REPLACING WITH A NEW ABRASIVE
WHEEL. IT IS POSSIBLE THAT THE WHEEL MAY CONTACT ANY
ITEMS OR STRUCTURE THAT EXTENDS ABOVE WORK SURFACE
(UNDER THE BASE) WHEN THE ARM IS FULLY LOWERED.
FIG. 9
SPINDLE SHAFT
WHEEL LOCK LEVER
5
FIG. 10
WHEEL
M10
FLANGE,
FLANGE,
BOLT
INSIDE
OUTSIDE
INTERNAL
FLAT
THREAD
WASHER