Safety Devices - Black and Decker BXAE00022 Manual Del Usuario

2.5. Safety devices

The battery charger is equipped with safety devices to ensure the utmost safety
during use and operation.
 Full protection against sparks
 Protection against short-circuits
 Voltage compensation
 Protection against overheating
 Protection against polarity reversal
 High protection rating against external agents, IP65
2.6. Battery tests and error indications
The battery charger is designed to determine the battery's condition before and
while charging, and inform about any connection faults between the battery charger
and the battery to charge.
LED / Icon
/Error
 Blink
 Blink
CAUSE
Very low battery.
The clamps/rings
output lead are not connected
correctly to the
Polarity reversal.
Battery voltage too high.
You are attempting to charge
a 24V battery with the charger
settled at 12V or you are
attempting to charge a 12V
battery with the
settled at 6V.
Battery capacity excessive.
Battery cannot maintain a
good level of charge.
Battery flat.
The battery may be defective.
Battery unrecoverable after a
complete desulfurization
cycle.
SOLUTION
Charger is trying to recover
the battery.
of the Position
correctly and start charging
battery. the battery again.
Check the battery voltage.
charger
Use battery
greater charging capacity.
The battery may be defective.
Contact your battery service
center.
Press the button again, to
restart charging, and try to
recover the battery.
Contact your battery service
center.
The battery may be defective.
Contact your battery service
center.
6
the clamps/rings
charger with