Heath Zenith DualBrite 5716 Manual De Instrucciones página 3

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

TEST AND ADJUSTMENT
❒ Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1
1
it will detect motion. W hen first turned on or when
switching modes wait 1
❒ Turn the RANGE control to the medium position
(halfway between MIN and MAX), D
and the ON-TIME control to the TEST position.
NORMAL SOFT FLASH
ON-TIME
MIN
MAX
TEST 1 5 20
RANGE
Bottom of Sensor
Avoid aiming the sensor at:
• Objects that change temperature rapidly, such as heat-
ing vents and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or unwanted traffic may trigger the
control.
• Nearby large, light-colored objects reflecting light may
trigger the shut-off feature. Do not point other lights at
the sensor.
8 ft.
(2.4 m)
70 ft.
(21 m) (30.5 m)
Boosted
Maximum Range
NOTE: If fixture is mounted higher than 8 ft. (2.4 m), aiming
the sensor down will reduce coverage distance.
The detector is less sensitive to motion directly towards it.
Motion
Sensor
Least Sensitive
598-1307-01
All manuals and user guides at all-guides.com
/
minute warm up period before
2
/
minutes.
1
2
B
to OFF,
®
ual
rite
LAMP MODE
DUAL BRITE™
OFF 3 6 DUSK TO
MINUTES
HOUR
DAWN
100 ft.
Maximum
Coverage Angle
Motion
Most Sensitive
❒ Loosen the clamp screw in the
sensor ball joint and gently rotate
the sensor.
❒ Walk through the coverage area
noting where you are when the
lights turn on. Move the sensor
head up, down, or sideways to
change the coverage area. Keep
the sensor at least 1" (2.5 cm)
away from the lamps.
❒ Adjust the RANGE as needed.
RANGE set too high may
increase false triggering.
❒ Secure the sensor head's aim
by tightening the clamp screw.
Do not overtighten the screw.
❒ Set the amount of T IME you want
the lights to stay on after motion is
detected (1, 5, or 20 minutes).
❒ Set the D
B
ual
dusk you want the lights on at low level (Off, 3, 6 Hrs.,
Dusk-to-Dawn).
❒ Set the LAMP MODE switch to the desired light turn-
on effect (Normal, Soft, Flash).
SPECIFICATIONS
Range . . . . . . . . . . . . Up to 70 ft. (21 m); 100 ft.
Sensing Angle . . . . . . Up to 270°
Electrical Load . . . . . . Up to 300 Watts Maximum Incan-
Power Requirements . 120 VAC, 60 Hz
270°
Operating Modes . . . . TEST, AUTO and MANUAL
Lamp Modes . . . . . . . Normal, Soft, Flash
Time Delay . . . . . . . . 1, 5, 20 minutes
D
B
Timer . . . . Off, 3, 6 hours, Dusk-to-Dawn
®
ual
rite
HeathCo LLC reserves the right to discontinue products
and to change specifications at any time without incurring
any obligation to incorporate new features in products
previously sold.
3
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
switch to the amount of time after
®
rite
(30.5 m) with Range Boost. [varies
with surrounding temperature]
descent
MODE
Clamp
Screw
Ball
Joint
Tabla de contenido
loading

Tabla de contenido