How To Use - Remington HC5810 Manual De Instrucciones

LED FUEL GAUGE
When the clipper is fully charged, all green LED lights will be on.
Use product until battery is low. This is indicated by illuminated red fuel gauge.
When the clipper is charging the green LED lights will flash.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period of time (2-3 months), unplug it from the mains and store. Fully recharge
your hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.
BEFORE STARTING THE CUT
1.
2.
3.
TO ATTACH A COMB
Hold the comb with its teeth upward.
Slide it onto and along the clipper blade until the front of the comb firmly sits against the
clipper blade.
TO REMOVE THE COMB
Holding the clipper with the blades facing away from you, firmly push the comb upward and
away from the blades.
ATTACHMENT GUIDE COMBS
Each guide comb is marked accordingly on its outside surface (3mm, 6mm, 9mm, 12mm,
16mm, 20mm, 30mm, 35mm, 40mm).
2
100166_REM_IFU_HC5810_21L.indd GB2 100166_REM_IFU_HC5810_21L.indd GB2
ENGLISH

HOW TO USE

Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
26.03.10 16:35 26.03.10 16:35