DeWalt DWE357 Traducido De Las Instrucciones Originales página 26

EN GLI SH
Mains Plug Replacement
(U.K. & Ireland Only)
If a new mains plug needs to be fitted:
• Safely dispose of the old plug.
• Connect the brown lead to the live terminal in
the plug.
• Connect the blue lead to the neutral terminal.
WARNING: No connection is to be
made to the earth terminal.
Follow the fitting instructions supplied with good
quality plugs. Recommended fuse: 13 A.
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1.5 mm 2 ; the maximum length
is 30 m.
When using a cable reel, always unwind the cable
completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Variable Speed Trigger Switch
(fi g. 1)
WARNING: This tool has no provision
to lock the switch in the ON position,
and should never be locked ON by any
other means.
The variable speed trigger switch (a) will give you
added versatility. The further the trigger is depressed
the higher the speed of the saw.
CAUTION: Use of very slow speed is
recommended only for beginning a cut.
Prolonged use at very slow speed may
damage your saw.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
24
WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Blade Installation and Removal
(fi g. 2–4, 7)
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories. An
accidental start-up can cause injury.
Different blade lengths are available. Use the
appropriate blade for the application. The blade
should be longer than 89 mm (3-1/2") and should
extend past the shoe and the thickness of the
workpiece during the cut. Do not use jigsaw blades
with this tool.
WARNING: Cut hazard. Blade
breakage may occur if the blade
does not extend past the shoe and
the workpiece during the cut (fig. 2).
Increased risk of personal injury, as well
as damage to the shoe and workpiece
may result.
TO INSTALL BLADE INTO SAW
1. Pull blade clamp release lever (c) up (fig. 3).
2. Insert blade shank from the front.
3. Push blade clamp release lever down.
NOTE: The blade can be installed in four positions
as shown in Figure 4. The blade can be installed
upside-down to assist in flush-to cutting as shown
in Figure 7.
TO REMOVE BLADE FROM SAW
CAUTION: Burn hazard. Do not touch
the the blade immediately after use.
Contact with the blade may result in
personal injury.
1. Open up blade clamp release lever.
2. Remove blade.
Proper Hand Position (fi g. 1, 5–9)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.