Electrolux EAWE09E2CJW Manual De Instrucciones página 16

29 electrolux installation
Installation procedure
1. Remove the sticker from the front
panel.
2. Put the unit into the installation
hole.
3. When installing the unit, it should
be slanted down to the back to
avoid the enlargement of noise or
vibration (Slant between 6-10mm).
4. The installation place should be
strong enough to avoid the
enlargement of noise or vibration.
5. Fill up sews in the cabinet with
sponge or foam.
Installation assistance
1. Use iron support. The installation
hole should be strong enough to
support the air conditioner. If it
cannot, iron support has to be
used outdoors. Iron support should
be fixed on the building (Shown at
right figure).
2. Use sunshade board. Air
conditioner should avoid anything
to be dropped into it and avoid
direct sunshine. If there is no cover
on it, you should contact the seller
for installing the sunshade board.
When installing the sunshade
board, don't let it block the air inlet
at the side grille.
All manuals and user guides at all-guides.com
6 ~10mm
Sunshade board
Wooden
Rubber
frame
plate
6 ~10mm
Support
Horizontal line
Drain water
To get the maximum cooling
efficiency, the air conditioner is
designed to splash the condensation
water on the condenser coil.
If the splashing sound annoys you,
you can provide an outside drain by
using the following procedure, which
may however cause a small loss of
performance.
1. Slide out the chassis from the
cabinet.
2. Remove the rubber plug from the
body base plate.
3. Install the drain pan to the corner
of the cabinet with 2 screws.
4. Connect the drain hose to the
outlet on the drain pan bottom.
5. Slide the chassis into its original
place in the cabinet.
Drain hose or tubing can be purchased locally to satisfy your particular needs.
installation electrolux 30
Internal view
Screws
Drain pan
External view
Drain hose