Russell Hobbs 19450-56 Instrucciones página 66

Read the instructions, keep them safe, pass them on if you pass the appliance on.
Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of a responsible adult. Use and
store the appliance out of reach of children.
2 Don't put the appliance in liquid, don't use it in a bathroom, near water, or outdoors.
3 Unplug before dismantling or cleaning.
4 Switch off (0) before fitting the jug to the motor unit.
5 Switch off (0), and wait till the blades come to a stop before removing the lid from the jug, or
removing the jug from the motor unit.
6 Don't fill with anything hotter than you can comfortably handle (i.e. liquid temperature
below 40°C).
7 Don't put your hand into the jug, even after you've removed it from the motor unit – the
blades are sharp.
8 Don't put any other object (spoon, spatula, etc.) into the jug while the blender is plugged in.
9 Don't leave the appliance unattended while plugged in.
10 Don't let the jug overflow. If liquid gets under the motor unit, it may be sucked into the motor,
damaging it.
11 Don't use accessories or attachments other than those we supply.
12 Don't use the appliance for any purpose other than those described in these instructions.
13 Don't operate the appliance if it's damaged or malfunctions.
14 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
C PREPARATION
1 Sit the motor unit on a dry, firm, level surface, near a power socket.
2 Hold the jug above the motor unit, with the handle between the speed control and the u
arrow on the motor unit.
3 Lower the jug on to the motor unit, then turn the jug to align the handle with the u arrow
on the motor unit.
4 Turn the lid clockwise to unlock it (U), then lift it off the jug.
5 Put the ingredients into the jug.
6 Don't fill past the 1500ml mark. If you do, the contents may force the lid off when you start
the motor.
C FIT THE LID
7 Fit the lid, with the tab in front of the handle.
8 Turn the lid anti-clockwise (L) till the latch clicks into the safety interlock.
9 Push the cap into the hole in the lid.
10 Don't run the appliance without fitting the cap.
C SWITCH ON
11 Check that the speed control is set to 0.
12 Put the plug into the power socket.
C SPEED CONTROL
13 Turn the speed control to the speed you want (1 = low, 2 = high).
14 Turn the speed control back to 0 to turn the motor off.
household use only
66