Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The pumping height can be regulated by means of the float switch
The pumping height can be regulated by means of the float switch
(4) and its position in the float switch locking device (3).
(4) and its position in the float switch locking device (3).
Please observe the following information regarding the float switch
Please observe the following information regarding the float switch
(4):
(4):
▶ Make sure that the float switch (4) always has enough clearance
▶ Make sure that the float switch (4) always has enough clearance
and is not permanently activated. This could prevent the automatic
and is not permanently activated. This could prevent the automatic
switch-off causing the device to run dry. This would damage the
switch-off causing the device to run dry. This would damage the
pump.
pump.
▶ Make sure that the float switch (4) is able to move freely and does
▶ Make sure that the float switch (4) is able to move freely and does
not suffer from a limited mobility caused by obstacles.
not suffer from a limited mobility caused by obstacles.
▶ Observe a sufficient distance between float switch (4) and float
▶ Observe a sufficient distance between float switch (4) and float
switch locking device (3), for this could prevent the automatic
switch locking device (3), for this could prevent the automatic
switch-off causing the device to run dry.
switch-off causing the device to run dry.
▶ Make sure that the position of float switch (4) is adjusted in a way,
▶ Make sure that the position of float switch (4) is adjusted in a way,
that it does not lie flat on the ground. This could prevent the auto-
that it does not lie flat on the ground. This could prevent the auto-
matic switch-off causing the device to run dry.
matic switch-off causing the device to run dry.
If required, lock the float switch (4) in
the desired position by pushing the
cable into the float switch locking
device (3) at the side of the pump. (see
fig. 9), when the float switch is at a
certain water level, it will automatica-
lly start or shut off. (see fig. 9)
POSITIONING THE DEVICE
POSITIONING THE DEVICE
Please observe the following information regarding the device
set-up and before switching the device on:
▶ The float switch (4) must be able to move freely. The shaft into
which the device is lowered must not restrict the mobility of the
float switch (4) in any way.
▶ Do not leave the device running unattended.
▶ Make sure that the device is firmly placed on the ground or safely
suspended.
▶ When using the device in bodies of water with natural, muddy
ground, set the device up at a slightly elevation position, e.g. on
bricks.
▶ Check whether the hose or pipe was attached properly.
▶ Make sure that the power cable (2) is not under tensile load and
has enough clearance.
▶ Make sure that the mains connection corresponds to the specifi-
Instruction manual
Ref. 08790 / Ref. 08791
fig.9
ES
PT
EN
FR
Tabla de contenido
