American Standard Passage A8011T-RHO Instrucciones De Instalación página 3

3
Mix a non-shrinking bedding material such as mortar and apply enough bedding material to support the entire bottom
of the shower base.
Concrete is NOT recommended. The shower base is NOT to be supported by the base flange.
BEDDING MATERIAL
FIGURE C
FIGURE C
4
After the bedding material has been poured and before it sets, lower the shower base into position with the drain assembly
sliding over the waste pipe (Fig. C). It will be necessary to "rock" the shower base until the top of the tile flange aligns with
the lines drawn on the stud walls from Step 1. Make sure the apron is contacting the rough floor along the entire length of the
shower base and ensure that the base is level in two directions as shown in Figure D.
Note: Allow the bedding material to completely harden before applying weight to the bottom of the shower base.
Place strainer back into place and conduct a water test of drain and plumbing to ensure there are no leaks.
5
Tape over the strainer to protect the finish and prevent construction debris from entering the drain.
Finish installation as shown in Figure E.
NO BEDDING CROSS SECTION OF
MATERIAL UNDER SHOWER BASE
BASE FLANGE
3-1/2"± 1/8"
(89± 3mm)
SUPPORTS
5" (127mm)
SHOWER BASE
Level base in two directions.
FIGURE D
FIGURE D
Caulk
Shower
Base
FIGURE E
FIGURE E
ROUND SHOWER
STRAINER TYPE DRAIN
Bedding
Material Area
2" (51mm)
PVC Pipe
Level
Level
Tile
Waterproof
Drywall
Tile
Adhesive
Stud
- 3 -
2 x 4"
(51 x 102mm)
Stud Wall
755467-100 Rev. 3 07/20