Care And Maintenance; Troubleshooting - Garden Treasures C864-62 Manual Del Usuario

OPERATING INSTRUCTIONS
1. Plug in the pump cord into the transformer (M).
2. Make sure the fountain is level after it is set up.
There are three adjustable feet on the bottom of the
base (D).
3. Fill the bottom bowl with 3-1/2 in. of clean water.
Completely fi ll the top bowl with clean water. Pour 2
cups of water down the top cap to prime.
Your fountain is ready to plug in and use.
4. You may adjust the water fl ow by turning the top cap
(L) on the inside of the plastic nozzle (MM) to the left to
increase the fl ow and to the right to decrease the fl ow.
5. Make certain the water level is not lower than the water
fi ll line in order to achieve maximum performance.
The pump won't be able to pump the water up without
enough water in the bottom bowl.
.
M
D
C
L
MM
water fi ll line
Lowes.com/gardentreasures
8

CARE AND MAINTENANCE

• Clean out the water intake area of the pump regularly to prevent pump damage. This can become
plugged easily due to dirty water and outside debris
• If the fountain will not be used for an extended period of time, disconnect the power and empty
the bowls. NOTE: Do not operate the fountain below 32°F (0°C). Freeze damage could occur.
Store the fountain indoors during freezing weather to avoid damaging the water pump.
• This fountain is made with an old world, traditional handcrafted look. Because of the nature of
cast iron or aluminum, the surface and the design may be rough.
• Slight pinholes are also present in the metal casting that is customary to handcrafted original iron
work. These irregularities enhance the individuality of the item. They should not be considered
defects.
• The powder coated cast iron frame and aluminum can be treated with a good quality car wax to
enhance and protect the fi nish. Should the fi nish get scratched down to the metal surface, cover
the scratched area with enamel paint as soon as possible to prevent rust.
• Cleaning – Use mild soap and water. Do not use harsh abrasive material, cleansers or bleach
products. Rinse with clean water and dry thoroughly with rags or direct sunlight.
• Periodically check and tighten all bolt connections.

TROUBLESHOOTING

PROBLEM POSSIBLE CAUSE
Pump operates, 1. Improper setting on pump water
but there is no fl ow control switch.
water fl ow. 2. Kink in water tube.
3. Dirt and debris in the water intake
on the pump.
Lights are not 1. Wire is not connected to the power
working. source.
2. Bulbs are burned out.
Water leaks from 1. Misaligned rubber plug or gasket.
the fountain.
CORRECTIVE ACTION
1. Make sure the pump's fl ow control
switch is set to "middle" water fl ow
position then adjust the water fl ow
to the desired level.
2. Check the tubing for kinks and
obstructions.
3. Make sure the water intake on the
pump is cleaned out regularly as
debris will build up from dirty water.
1. Double-check all connections.
2. Replace bulbs.
1. Make sure the rubber plug and
rubber gaskets are installed and
tightened properly.
Lowes.com/gardentreasures
9