Makita GSL03 Manual De Instrucciones página 26

Sub base
Optional accessory
WARNING:
Always support a long workpiece
so it is level with the top surface of the turn base
for an accurate cut and to prevent dangerous loss
of tool control. Proper workpiece support will help
avoid blade pinch and possible kickback which may
result in serious personal injury.
WARNING:
Before the cutting operation,
always be sure that a sub base is secured by the
screw.
NOTE: For details on installation, follow the instruc-
tions provided with an optional sub base.
Install an optional sub base in the base to hold long workpieces more securely. Loosen the screw and
extend the sub base to the appropriate length for hold-
ing the workpiece. Then tighten the screw.
1 2
► 1. Sub base 2. Screw
When cutting, place the workpiece flat against the guide
fence and the sub fence on the sub base.
► 1. Guide fence 2. Sub fence 3. Sub base
Adjusting sub fence
Adjust the sub fence on the sub base if it is not aligned
with guide fence.
1.
hex wrench.
2.
member, flat against the guide fence.
3.
sition the sub fence so that the face of the sub fence
becomes flat against the bar. After that, tighten the
bolts.
► 1. Bolt 2. Sub fence 3. Guide fence 4. Rigid bar
OPERATION
This tool is intended to cut wood products. With appro-
priate Makita genuine saw blades, following materials
can also be sawed :
—
Refer to our website or contact your local Makita dealer
for the correct circular saw blades to be used for the
material to be cut.
contacting the workpiece, etc. before the switch
is turned on. Turning the tool on with the blade in
contact with the workpiece may result in kickback and
serious personal injury.
1 2
not raise the saw blade until it has come to a
complete stop. The raising of a coasting blade may
result in serious personal injury and damage to the
workpiece.
3
such as turning grip, knob, and levers on the tool
while the saw blade is rotating. Adjustment while
the blade is rotating may result in serious personal
injury.
26 ENGLISH
Loosen the bolts securing the sub fence using the
Place a straight rigid bar, such as a square steel
While the bar is flat against the guide fence, repo-
3
4
1
2
4
Aluminum products
WARNING:
Make sure the saw blade is not
WARNING:
After a cutting operation, do
WARNING:
Do not perform any adjustment