Tool Specifications; Operating Controls; Intended Use; Initial Operation - Würth master H 26-ACM Manual De Instrucciones

H 26 ACM.book Seite 9 Freitag, 25. November 2005 8:37 08

Tool Specifications

Rotary Hammer
Order number
Rated power
No-load speed
No-load impact frequency
Impact energy per stroke
Chisel positions
Tool holder
Clamping collar diameter
Drilling output:
- Wood
- Steel
- Concrete
- Brickwork
Weight (without accessories)
approx.
Protection class

Operating Controls

1 Dust protection cap
2 Locking sleeve
3 Locking collar for tool mounting
4 Depth stop button
5 Depth stop
6 Mode selector switch
7 Release button for mode selector switch
8 Rotational direction switch
9 On/Off switch
10 Auxiliary handle
Not all of the accessories illustrated or described are included
as standard delivery.

Intended Use

The machine is designed for drilling in concrete,
brick and stone as well as for chiselling. It is also suit-
able for drilling without impact in wood, metal,
ceramic and plastic.
The user is responsible for damage caused by usage
other then intended.
Observe correct mains voltage: The voltage of the
H 26-ACM
power source must agree with the voltage specified
0702 229 X
on the nameplate of the machine.
710 W
Mounting the side handle (see figure A)
0 –1 100 rpm
0 –4 200 bpm
0 – 3.1 J
Loosen the grip of the side handle 10.
51
Put the side handle into the desired position.
SDS-plus
Firmly tighten the grip of the side handle.
54 mm
Adjusting the depth rod (see figure B)
max. 30 mm Push button 4 for depth stop 5.
max. 13 mm
Adjust the depth rod to match the desired drilling
depth.
max. 26 mm
Release button for depth stop.
max. 65 mm
Selecting the operating mode
3.1 kg
/ II
Press the release button 7 down.
Set the mode selector switch to the desired setting
and then let go of the release button.
Reversing the Rotational Direction
The rotational direction switch 8 is used to reverse
the rotational direction of the machine. However, this
is not possible with the On /Off switch 9 pressed.

Initial Operation

Only work with the machine if the side han-
dle is mounted.
Only use the mode selector
switch 6 after the machine has
come to a full stop.
Drilling (non-impact)
Impact drilling
Adjusting the tool accessory
Chipping (with spindle lock)
Operate the rotational direction switch 8
only at a standstill.
Right Rotation
Turn the rotational direction
switch through to the left stop
(normal operation: drilling).
Left Rotation
Press the rotational direction
switch through to the right stop.
9