Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION CONTINUED
• T he electrical cord of this product cannot be replaced. If it sustains
damage, you must stop using this product immediately and return it to
the HoMedics Service Center for repair. (See the warranty section for
HoMedics address.)
• D isconnect the appliance from outlet before putting hands into water.
I. Fountain lid
D. Oil dish
C. Fountain
top
F. Tea light
Clean water
B. Pump
A. Fountain base
Package Contents
Part
Description
A
Base
B
Pump
C
Fountain Top
D
Oil dish
E
Aroma Oil
F
Tea Light
G
Power Adaptor
H
Cleaning Pin
I
Fountain Lid
J
River Rocks
4
Cleaning pin
mark
Rainfall
H. Cleaning
hole
pin
Fountain lid
G. Adaptor
J. River rocks
Power cord
Switch
E. Aroma oil
Quantity
1
1
1
1
1
2
1
1
1
Varies
Assembly and Instructions for Use
Unpack the product. Be sure that all parts listed are included. Familiarize
yourself with the WATER PUMP (B) before completing assembly of the
fountain. It is recommended that the WATER PUMP be set at its highest
speed during assembly and later adjusted to a lower setting if desired.
Adjusting the WATER PUMP speed:
The WATER PUMP speed is controlled by the switch located at the front of
the WATER PUMP (Figure 8).The speed is indicated by a plus(+) and minus
(-) sign. To increase the speed, move the switch slowly in the direction
of the plus sign. At its highest speed level, the switch will not move any
further. To decrease the WATER PUMP speed, move the switch toward
the minus sign. Similarly, at its lowest speed, the switch will not move any
further .Once you are familiar with the WATER PUMP, begin assembly.
Attention:
To get the best results, please operate pump completely submerged. Keep
the water level above the minimum water level (Figure 8) at ALL TIMES.
Fountain Assembly:
1. Place the pump cord through the cord slot on the bottom of the base
(Fig 1).This will ensure that the unit is balanced when placed on a flat
surface.
Fig 1
Flat surface
Cord slot
5
Base
Pump power cord
Tabla de contenido
