Maclaren techno xlr Manual Del Usuario página 11

EN
Instructions
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP THEM FOR FUTURE REFERENCE.
IMPORTANT:
• YOUR CHILDREN'S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW THESE INSTRUCTIONS.
1 TO OPEN THE STROLLER
A Release storage clip.
B Open out the stroller.
C Using foot, push the footplate down fully to engage the primary lock.
WARNING: Ensure that all locking devices are engaged before use.
2 TO OPERATE BRAKES
A TO ENGAGE BRAKES: With foot, pull the brake levers fully back.
B TO RELEASE BRAKES: Push the brake levers fully forward.
WARNING: Parking device shall be engaged during the loading and unloading
of children.
WARNING: Ensure parking device is engaged before leaving the buggy
unattended.
3 TO OPERATE FRONT WHEEL SWIVEL LOCKS
A TO LOCK SWIVELS: Lift BOTH swivel locking levers.
B TO UNLOCK SWIVELS: Push down BOTH swivel locking levers.
4 SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: Avoid serious injury from falling or sliding out. Always use the crotch
strap in combination with the waist belt and shoulder straps.
TO FIT HARNESS:
A Pull shoulder straps over the childs shoulder then attach to the waist
clips by sliding strap loops onto the hooks.
B Insert both waist clips into the clasp, shoulder straps are secured once
the clips are fastened.
C Adjust strap lengths by sliding buckles. Belt and harness should be snug.
'D' rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D Press the button on both the front and back of the clasp simultaneously
to release.
5 TO FIT HEAD CUSHION
A Unclip shoulder harness straps from clasp and pass through head
cushion holes.
6 TO FIT HARNESS PADS
A Lay open pad under shoulder harness strap.
B Fold pad over and secure Velcro strips.
7 TO OPERATE THE LEGREST
TO EXTEND THE LEGREST: Feel through seat corner openings. Locate sliders
and pull forward. Reverse this process to retract legrest.
8 TO ADJUST SEAT RECLINE
A
TO RECLINE THE SEAT: Squeeze the seat recline lever to raise or lower the seat
to the desired position. Release the seat recline lever ensuring both sides lock
at the same recline angle. The seat back may be raised by lifting the seat back
to the desired position.
B TO RAISE SEAT BACK: From rear of stroller push seat back to original upright or
desired intermediate position.
9 TO ATTACH THE HOOD
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum total capacity of hood pockets - 1.1 lb (0.5 kg).
A With stroller open clip the hood to the handle tubes just above the
retaining blocks.
B Wrap velcro strips around handle tubes.
C Place rear apron behind seat back.
D Extend hood and press down on side hinges to lock open.
TO TILT HOOD:
E Fully unzip back panel.
F
Tilt hood forward.
G The hood is removed by firmly pressing down the clip release tabs.
10 TO ADJUST HANDLE LENGTHS
A Press triggers.
B Slide handles until triggers locate in one of 3 positions. Release triggers
to lock.
11 TO FIT THE RAIN APRON
A Return hood to non-tilted position before fitting rain apron.
B Ensure visor is folded away beneath the hood.
C Place the apron over the hood front.
D Attach two eyelets (one each side) to the hood clips.
E Attach the two eyelets (one each side) to the front legs.
12 TO FIT THE SHOPPING BAG
CAUTION: Overloading may cause a hazardous unstable condition to exist.
Maximum load 4.4 lb (2 kg) evenly distributed.
The stroller may be folded with the bag still attached but all contents must be
removed. Failure to do this could damage stroller and contents of shopping
bag.
A Place bag on the 'X' frame under seat with lowest edge of bag at front.
B Attach front straps to front legs just below seat.
C Attach rear straps to rear legs just above horizontal tie bar.
13 TO FOLD THE STROLLER
Ensure visor is folded away beneath the hood.
Ensure the seat back is in its fullest upright position and the hood(if fitted) is
folded back.
Remove contents of shopping bag.
It is recommended that the harness is fastened before folding the stroller.
A Using foot, lift up on footplate to release primary lock.
B Push down on secondary lock lever.
C Grip handles and push forward.
D Compress folded stroller and engage the storageclip.
14 REMOVING AND REFITTING THE SEAT COVER
Remove hood, shoulder pads and head cushion from stroller if fitted.
A Twist shoulder strap end buckles and feed through holes.
B The waist harness back strap is fixed to the chassis behind the seat.
To remove, twist the buckles on each end of the harness back strap and
unthread from the 'D' rings attached to the chassis.
IMORTANT – It is important that the strap be rethreaded through the 'D'
rings after the seat has been refitted. Failure to do so will endanger your
child.
C Feed crotch strap buckle through holes.
D Unclip seat cover retaining straps.
E Unfasten seat fabric from handle tubes and seat base.
F Slide fabric from seat back and base.
G When refitting seat fabric, insert seat back support tubes into fabric flap.
H When refitting shoulder straps, choose the fabric holes appropriate to
the child's size. Twist the buckles and feed through seat cover, seat back
and then through holes in plastic seat back arms.
J When refitting seat fabric to seat base pass crotch strap buckle through
the hole in the seat fabric and then hole in seat base.
3