BGS technic 9790 Manual De Instrucciones página 3

SPECIFICATIONS
Dimensions:
Height: 1020 mm
Width: 690 mm
Depth: 400 mm
Usable for component sizes:
Width: 305 mm
Height: 380 mm
Capacity: 10 Tons
Hydraulic Ram Stroke: 130 mm
Read and understand the entire instruction manual before attempting setup, or operation of this Hydraulic
Workshop Press.
FEATURE
Used for parts straightening, bending and pressing. Multi-position bed for work height adjustment.
WARNINGS
•
This press is designed and intended for use by properly trained and experienced personnel only. If
you are not familiar with the proper and safe operation of a hydraulic press, do not use until proper
training and knowledge has been obtained.
•
Do not operate this press beyond it rated capacity.
•
Do not compress springs or other objects that could be ejected from the press.
•
Do not compress objects that could shatter.
•
Observe the maximum working stroke of the workshop press in order not to damage parts.
•
Check the press for loose or damaged parts before each operation. Replace damaged parts and
tighten all loose bolts before operating.
•
Some parts being pressed may have a tendency to pop out of the press or explode under pressure.
Protect yourself accordingly.
•
Keep hands away from the pressure head and out of support rod holes.
•
Always center the work piece on the table plates and center the pressure head on the work piece to
prevent injury by ejection of the work piece.
•
Always wear safety glasses I face shields and personal safety equipment.
OPERATION
1. Place work piece on bed frame.
2. Locate and close release valve by turning it clockwise until tight.
3. Pump handle until the ram nears work piece.
4. Align ram and work piece to ensure center loading.
5. Apply load to work piece by pumping handle. Do not overload work piece.
6. Remove load from work piece by turning release valve counter-clockwise. Stabilize workpiece so it
does not fall while pressure is released.
7. Remove work piece after ram is fully retracted.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Hydraulic Workshop Press
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
BGS 9790
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed