Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MEASURING FREQUENCY
1.- Connect the red testing point to the jack signaled "V Ω" and
the black testing point to the jack signaled "COM".
2.- Set the dial to 20kHz range.
3.- Connect the testing points to the circuit to be measured.
4.- The frequency will appear on the LCD screen.
Measures over 10V rms are allowed, but the accuracy is not
Measures over 10V rms are allowed, but the accuracy is not
guaranteed.
guaranteed.
WARNING
Before removing the cover from your multimeter, make sure the
testing points are disconnected to avoid the risk of electrical
shock.
REPLACING THE BATTERY AND THE FUSE
The fuse rarely needs to be replaced and when it does, it is usu-
ally due to an error in operation.
If "BAT" appears on your LCD screen, the battery needs to be
replaced.
To replace the fuse ( F1: 200 mA / 250 V y F2: 10 A / 250 V ) or
the battery remove the cover from the multimeter removing the
three screws on the back of the multimeter. Replace the fuse
and/or battery and replace the cover on your multimeter.
HOLDER
Place the holder up to three different positions, in order to obtain
an easy LCD reading.
ACCESSORIES
•
User's manual
•
Testing points
•
Battery
•
Thermo pair type K
•
Case
The characteristics for this multimeter are subject to change
The characteristics for this multimeter are subject to change
without notice.
without notice.
ENGLISH-10
Tabla de contenido
