Wash Cycles; Jdaily Cleaning; Machine Cleaning; End Of Service - Zanussi Professional ZXSG Instrucciones De Operación

I.5

Wash cycles

The wash cycle includes one wash with hot water and
detergent (min 55℃ [131℉]) and one rinse with hot water and
rinse-aid (min 82 ℃ [180℉]).
Table of times: standard cycle time with supply water at
50℃ [122℉]
Model
EXS.... - NXS.... - VXS.... - ZXS.... -
ES.... - NS.... - VS.... - ZS....
ESGWM - ZSGWM
J DAILY CLEANING
WARNING
Refer to "Safety Information".
J.1

Machine cleaning

Cleaning must be carried out after every day of use. Use hot
water, a neutral detergent/cleaner if necessary, and a soft
brush or sponge. If another type of detergent is used, carefully
follow the producer's instructions and observe the safety rules
given in the information sheets provided with the product or
substance.
In order to reduce the environmental impact of pollutants it is
advisable to clean the machine (externally and, where
necessary, internally) with products that are more than 90%
biodegradable.
CAUTION
Do not use steel wool or similar material to
clean stainless steel surfaces. Do not use
detergents containing chlorine.
WARNING
When using chemicals, comply
with the safety notes and dosage
recommendations printed on the
packaging. Refer to the chapter
A.3 Personal protection equip-
ment for
products.
J.2

End of service

• Open the door and take out the rack containing the clean
glasses of cups.
120 sec
90 - 120 sec
handling chemical
30°C
86°F
NOTE!
Standard cycle time may vary should the inlet
water temperature and/or the boiler heating ele-
ments be different from that indicated above.
A device lengthens the cycle time if the water in the boiler has
not reached the minimum temperature for correct rinsing.
The cycle times and the temperature may be personalised (e.g.
increase of the rinse time and temperature). The cycle times
should only be set by a specialised personnel.
• Depending on the model, remove the flat filter "C" and the
overflow "A".
• Models without drain pump.
– Remove only the overflow pipe.
• Models with drain pump.
– Remove the overflow pipe. Close the door. Select the
drain cycle by pressing DRAIN button for at least 5
seconds until the washing tank is empty.
• Switch off the dishwasher by pressing ON/OFF button.
• Clean the tank.
– Remove any residues from the bottom of the tank with a
sponge and wash with clean water.
For cleaning, use washing-up detergent or water and
vinegar solution. Do not use abrasive detergents or
powers that might damage the internal parts.
To eliminate any incrustation, use a sponge or brush with
soft plastic bristles.
• Switch off the mains ahead of the equipment.
• Close the water supply tap.
• Replace the flat filter and the overflow.
• Unscrew the ring nuts "H" and remove the washing "3" and
rinsing arms "4".
ENGLISH
15