Weston Butcher MG08 Serie Manual Del Usuario página 9

STANDARD STUFFER ASSEMBLY INSTRUCTIONS
WARNING
Entanglement Hazard. To avoid serious or fatal injury, never
w
reach into grinder feed chute. Always use stomper. Never operate without tray in
place. Secure long hair and loose clothing before use. Disconnect power before
assembling. Always read instructions.
1. Make sure Meat Grinder is
unplugged. Insert the Head into the
Gear Housing with the feed chute of
the Head facing straight up. You will
need to line up the slot in the Head
with the Key inside the Gear Housing.
Be sure the Head is seated fully into
the Gear Housing (FIGURE 5).
2. Tighten the Head-Locking Knob
to lock the Head into place.
3. Insert the Auger, with the Auger
Bearing attached, into the Head
(FIGURE 6). Align the Auger Splines
with the Drive Shaft of the Grinder.
NOTE: Periodically inspect the
Auger Bearing for wear. If the Auger
Bearing has excessive wear, replace
it to prevent head damage.
4. Slide the Stuffing Star over the round
portion of the Auger Pin.
5. Slide one of the Stuffing Funnels
through the Flange and place it
through the Front Ring Nut.
6. Install the Front Ring Nut. DO NOT
OVERTIGHTEN. Turn the Front Ring
Nut until it makes contact with the
Flange; then make 1/4 turn more
to tighten into place.
7. Insert the neck of the Tray into the
Feed Chute (FIGURE 7). Plug into
electrical outlet.
8. NEVER operate Grinder without the
Tray secured in place (FIGURE 7).
840303701 v15.indd 9
Feed
Slot in Head
Chute
Head
Drive Shaft
Gear
Housing
Auger Bearing
Auger Splines
Auger
Auger Pin
Stuffing Star
Stuffing Funnel
Flange
Front Ring
Nut
Tray
Neck
Feed
Chute
Head
FIGURE 5
Head-Locking
Knob
FIGURE 6
Head
FIGURE 7
Tray Support
Bracket (#22 &
#32 models only)
9
2/21/20 10:26 AM