Mounting The Guard - EGO STA1500 Manual Del Proprietário

MOUNTING THE GUARD

NOTICE: Install the guard before the
attachment is connected to the power head.
WARNING:
injury to persons, do not operate without
guards in place.
WARNING:
when mounting or replacing the guard. Be
careful of the blade on the guard and protect
your hands from being injured by the blade.
1. Loosen the two bolts in the guard
with the supplied hex wrench;
remove the bolts and spring
washers from the guard (Fig. 2).
2. Lift the trimmer head and face it
downward; align the two mounting
holes in the guard with the two
assembly holes in the base of the
shaft. Make sure that the internal surface of the guard faces towards the trimmer
head (Fig. 3).
3. Use the supplied hex wrench to lock the guard in place with the bolts.
CONNECTING THE STRING TRIMMER ATTACHMENT TO THE POWER HEAD
WARNING:
running or with the battery installed. Failure to stop the motor and remove the battery
may cause serious personal injury.
This string trimmer attachment is designed for use with EGO Power Head PH1400/PH1400-FC.
The string trimmer attachment connects to the power head by means of a coupler device.
1. Stop the motor and remove the battery pack.
2. Loosen the wing knob on the power-head coupler.
14
STRING TRIMMER ATTACHMENT — STA1500/STA1500-FC
To reduce the risk of
Always wear gloves
Never attach or adjust any attachment while the power head is
2
3