HQ-Power VDL25BM Manual Del Usuario página 2

• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
• The installation has to be approved by an expert before the device is taken into service.
4. Installation
a) Adding Bubble Liquid
• Only fill the tank when the device is unplugged from the mains.
• Use only bubble liquid without oil or grease. Any non recommended bubble liquid may damage the bubble
machine.
• Fill the tank only with specially designed water-based bubble liquid, order code VDLBL5.
1) Unscrew the screw caps on the left side of the tank holding the lid.
2) Pivot the lid downwards and remove the plastic tank.
3) Carefully pour bubble liquid into the tank.
4) Replace the tank and close the lid. Fasten.
Remark: Do not operate the device when the lid is off.
b) Replacing the fuse
• Only replace a fuse with a fuse of the same type and rating.
• Only replace a fuse when the device is unplugged from the mains.
• The fuse is an internal fuse. It should be replaced by your agent or an authorized dealer.
1) Unscrew the fuse holder on the back with an appropriate screwdriver.
2) Remove the old fuse and replace it with a new one.
3) Replace the fuse holder in the housing and fasten it with the screwdriver.
c) Mounting the device
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used. Have the material and the device itself checked regularly. Do not attempt to install the device
yourself if you lack these qualifications as improper installation may result in injuries.
• Before mounting make sure the installation area can hold a minimum point load of 10 times the device's weight.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• The installation has to be approved by an expert before the device is taken into service.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
5. Use
• Connect the power plug to the mains to start the bubble machine.
• Pulling the plug will stop the machine.
VDL25BM 2 VELLEMAN