Fanimation Camhaven v2 FP8094 Serie Manual De Instrucciones página 13

Assembling Fan With the Light Kit
If you are assembling your fan without the light kit, please skip to page 15 of this manual.
NOTE:
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
1. Disassemble the adapter switch cup assembly from
the switch cup support plate by removing three
screws. (Figure 1)
2. Disassemble the finial, trim cover and nut from
adapter switch cup assembly. (Figure 2)
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the switch cup support plate to the support bracket
using the two key slots in the socket plate. Replace
the third screw and securely tighten all three screws
(Figure 3).
3. Connect the 2 single pin connector from motor
assembly to the 2 single pin connector from the
adapter switch cup assembly. (Figure 4)
Switch cup support
plate
Nut
Motor
Assembly
13
Adapter Switch cup
assembly
Figure 1
Adapter Switch cup
assembly
Trim Cover
Finial
Figure 2
Switch cup
support plate
Figure 3
Adapter Switch cup
Figure 4
assembly