Toshiba Carrier RAS-09EKCV Serie Manual Del Usuario página 3

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

1
SYSTEM CHARACTERISTICS
1. Three-minute time delay: To protect against frequent compressor starts.
2. Some minor cracking sound may occur when unit operating. This is
normal and is caused by expansion/contraction of plastic.
Air conditioner operating conditions
Temp.
Outdoor Temperature
Operation
Cooling
0°F ~ 115°F (-18°C ~ 46°C)
Dry
0°F ~ 115°F (-18°C ~ 46°C)
2
INDOOR UNIT DISPLAY
3
PREPARATION BEFORE USE
Preparing Filters
1. Open the air inlet grille and remove the air fi lters.
2. Attach the fi lters. (see details in the accessory sheet).
Loading Batteries
1. Remove the battery cover.
2. Insert 2 new batteries (AAA type)
following the (+) and (–) positions.
Clock Setup
1. Push CLOCK
with the tip of a pencil.
If timer indication is fl ashing, go to the next step.
2. Press
ON
or
OFF
: adjust the time.
3. Press
SET
: Set the time.
Temperature Unit °F-°C Selection
1. Push and hold CHK
button on the Remote
Control with the tip of a pencil, "00" will be
shown on the display.
2. Press
while pushing CHK
SLEEP
Note: 1. Repeat above step to reset Remote
Control to be °F.
2. Operation mode and temperature
set will reset to initial settings after
changing the temperature unit.
3. Default setting of Remote Control
from factory is °F.
4
REMOTE CONTROL A-B SELECTION
In case of two systems operating nearby, follow the instructions below to set
the remote control to operate with one indoor unit at a time.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold CHK
button on the Remote Control with the tip of a
pencil. "00" will be shown on the display.
MODE
4. Press
while pushing CHK
will disappear and the air conditioner will turn OFF. B is now memorized.
Note: 1. Repeat above step to reset Remote Control back to A.
2. Remote Control does not display "A".
3. Default setting of Remote Control from factory is A.
"B" Display
"00" Display
1110655116-1_EN.indd 3
1110655116-1_EN.indd 3
Room Temperature
70°F ~ 90°F (21°C ~ 32°C)
62°F ~ 90°F (17°C ~ 32°C)
1 Hi POWER (Green)
2 FILTER (Orange)
3 FAN ONLY (Orange)
4 TIMER (Yellow)
5 OPERATION (Green)
6 RESET button
.
CLR
SLEEP
SET
. "B" will show on the display and "00"
5
AIR FLOW DIRECTION
FIX
1
Press
: Move the louver to the
desired vertical direction.
SWING
Press
: To continuously swing
2
the louver automatically and press
again to stop.
For horizontal direction, adjust
3
manually.
Note:
• Do not move the louver manually for anything else other than 3 above.
• The louver may automatically position for some operation modes.
6
REMOTE CONTROL
1 Infrared signal emitter
2 Start/Stop button
3 Mode select button (MODE)
4 Temperature button (TEMP)
5 Fan speed button (FAN)
6 Swing louver button (SWING)
7 Set louver button (FIX)
8 On timer button (ON)
9 Off timer button (OFF)
! Sleep timer button (SLEEP)
" Setup button (SET)
# Clear button (CLR)
$ Memory and Preset button
(PRESET)
% One-Touch button
(ONE-TOUCH)
& High power button
(Hi-POWER)
( Economy button (ECO)
) Quiet button (QUIET)
~ Comfort sleep button
(COMFORT SLEEP)
+ Filter reset button (FILTER)
, Clock Reset button (CLOCK)
- Check button (CHK)
Note: If using the optional wired remote controller, refer to its instructions.
Do not install batteries for hard-wire installation.
7
ONE-TOUCH
Press the "ONE-TOUCH" button for fully automated operation that is
customized to the typical consumer preferences in your region of the world.
The customized settings: control temperature, air fl ow strength, air fl ow
direction and others provide comfort with "ONE-TOUCH" of the button. If you
prefer other settings you can select from the many other operating functions
offered.
ONE-TOUCH
Press
: Start the operation.
8
AUTOMATIC OPERATION
To automatically select cooling or fan only operation
MODE
1. Press
: Select A.
2. Press
TEMP
: Set the desired temperature.
EN
ES
FR
PRESET
FAN
TEMP
ONE-TOUCH
MODE
COMFORT
QUIET
SLEEP
SWING
FIX
Hi-POWER ECO
TIMER
CLR
ON
OFF
SLEEP
SET
˚C/˚F
CHK
FILTER
CLOCK
18/11/56 17:05
18/11/56 17:05
Tabla de contenido
loading

Tabla de contenido