When using electrical appliances, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and/or
injury to persons, including the following:
1. Read all instructions.
2. This appliance is not intended for use by persons (including
children) with reduced physical, sensory, or mental
capabilities, or lack of experience and knowledge, unless
they are closely supervised and instructed concerning use of
the appliance by a person responsible for their safety.
3. Close supervision is necessary when any appliance is used
by or near children. Children should be supervised to ensure
that they do not play with the appliance.
4. To protect against risk of electrical shock, do not put base,
motor, cord, or plug in water or other liquid.
5. Unplug cord from outlet when not in use, before putting on
or taking off parts, and before cleaning.
6. Avoid contact with moving parts.
7. Keep hands, hair, clothing, as well as spatulas and other
utensils out of container to prevent personal injury or
damage to the mixer.
8. Do not operate any appliance with a damaged supply
cord or plug, or after the appliance malfunctions or has
been dropped or damaged in any manner. Supply cord
replacement and repairs must be conducted by the
manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard. Call the provided
customer service number for information on examination,
repair, or adjustment.
2
IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS
9. The use of attachments not recommended or sold by
the appliance manufacturer may cause a risk of injury to
persons.
10. Do not use outdoors.
11. Do not let cord hang over edge of table or counter or touch
hot surfaces.
12. Never add ingredients to container while appliance is
operating.
13. Container must be properly in place before operating
appliance.
14. To wash mixing shaft, unplug mixer and follow the cleaning
instructions provided on page 6.
15. Do not use this appliance for other than intended use.
16. Do not place on or near a hot gas or electric burner.
17. Check that the control switch is OFF ( ) before plugging
cord into electrical outlet. To disconnect, turn control to OFF
( ); then remove plug from electrical outlet.
18. CAUTION: In order to avoid a hazard due to inadvertent
resetting of the motor thermal cut-out, this appliance must
not be supplied through an external switching device,
such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.