Porter Cable PCC475 Manual De Instrucciones página 4

the blade may suddenly bind in the work and may cause the saw to kickback towards the
• When not in use, place tool on its side on a stable surface where it will not cause
operator.
a tripping or falling hazard. Some tools with large battery packs will stand upright but
• Keep hands away from cutting area. Never reach underneath the material for any
may be easily knocked over.
reason. Hold front of saw by grasping the contoured gripping area. Do not insert fingers
or thumb into the vicinity of the reciprocating blade and blade clamp. Do not stabilize the
• Keep blades sharp. Dull blades may cause the saw to swerve or stall under pressure.
saw by gripping the shoe.
• Use extra caution when cutting overhead and pay particular attention to overhead
wires which may be hidden from view. Anticipate the path of falling branches and debris
• Do not operate this tool for long periods of time. Vibration caused by the operating
ahead of time.
action of this tool may cause permanent injury to fingers, hands, and arms. Use gloves to
provide extra cushion, take frequent rest periods and limit daily time of use.
• When cutting pipe or conduit ensure that they are free from water, electrical wiring, etc.
• Do not touch the workpiece or the blade immediately after operating the tool.
They can become very hot.
• Do not use in rain or wet conditions.
WARNING:
glasses. Also use face or dust mask if drilling operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NOSH/OSHA respiratory protection.
WARNING:
other construction activities contains chemicals known to the state of California to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well ventilated area, and work
with approved safety equipment, such as those dust masks that are specially designed to
filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
WARNING:
serious and permanent respiratory or other injury. Always use NOSH/OSHA approved
respiratory protection appropriate for the dust exposure. Direct particles away from face
and body.
ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise
WARNING:
from this product may contribute to hearing loss.
This product can accept any of the batteries and chargers listed in the chart below.
Li-Ion Battery Packs and Chargers
Battery: Li-Ion 18V
Description
Charger: Li-Ion
ALWAYS use safety glasses. Everyday eyeglasses are NOT safety
Some dust created by power sanding, sawing, grinding, drilling, and
Use of this tool can generate and/or disperse dust, which may cause
Always wear proper personal hearing protection that conforms to
Cat. #
PC18BLX
PC18BLEX
PCLMVC
PCXMVC
NI-CD Battery Packs and Chargers
Battery: NI-CD 18V
Description
Charger: NI-CD
4
PC18B
Cat. #
PCMVC
PCXMVC