Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ADAPTER (CATALOG # BDCMTOA)
An accessory adapter kit is provided with BDCMTOA. The adapter is
compatible with many manufacturers' accessories, but if unsure, confirm
with the specific manufacturer that their accessory is compatible.
CAUTION:
To avoid injury, do not use any accessory for an
application where the adaptor may fail to hold the accessory.
CAUTION:
Read and follow all manufacturers' safety warnings
for any accessories used with this tool.
CAUTION:
To avoid injury, ensure adapter and accessory are
securely tightened.
CAUTION:
Do not use this adaptor with Black and Decker
accessories. Attach Black and Decker accessories with the
accessory clamping lever (2) according to the instructions in this
instruction manual.
• To attach, place adapter plate (7) onto the oscillating tool
attachment with protrusions facing up as shown in Figure E.
• Place accessory and the adapter bolt and washer (8) on top of
adapter and tighten with the hex wrench as shown in Figure F.
• To remove, loosen the bolt and washer with the hex wrench and
remove the accessory and adapter.
HELPFUL HINTS
• Always ensure the workpiece is firmly held or clamped to prevent movement. Any movement of
the material may affect the quality of the cutting or sanding finish.
• Do not start sanding without having the sandpaper attached to sanding platen.
• Use coarse grit paper to sand rough surfaces, medium grit for smooth surfaces and fine grit for
the finishing surfaces. If necessary, first make a test run on scrap material.
• Excessive force will reduce the working efficiency and cause motor overload. Replacing the
accessory regularly will maintain optimum working efficiency.
• Do not allow the sandpaper to wear away, it will damage the sanding platen.
Problem
• Unit will not start.
For assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BLACK & DECKER help line at 1-800-544-6986.
NOTE: Refer to Power Unit instruction manual for troubleshooting solutions regarding opera-
tion of the Power Unit.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
WARNING:
The use of any accessory not recommended for use with this tool could be hazardous.
Recommended accessories for use with your tool are available from your local dealer or authorized
service center. If you need assistance regarding accessories, please call: 1-800-544-6986.
TROUBLESHOOTING
Possible Cause
• Attachment is not secured.
Possible Solution
• Make certain the attachment is fully
pushed into the Power Unit.
7
E
7
Protrusion
F
8
Tabla de contenido
