Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
12
OPERATION
•
Fasten a hauling rope to the pump. With this rope you can pull the pump
out of the water as needed. Make the necessary hose connections(if
required), or install a fountain attachment. After the installation, insure
that there are no air bubbles in the hose system(lay hose lines on an
incline).
•
Install the pump horizontally on a fixed support at least 20 cm under the
water surface. Comply with the maximum permitted immersion. Depth
(see the information on the model plate).
•
Do not place the pump directly in the pond floor mud; place the pump on a
raised surface.
•
Lay the power cord in a protected manner to exclude the possibility of
damage.
•
Connect the pump to the electrical circuit.
Note: Never operate the pump without the filter basket. The filter basket
protects the pump from coarse dirt that can lead to plugging up the pump.
In winter, remove the pump from the water and store it in a frost-free
environment, if possible in a container filled with water, to prevent the O-ring
from drying out and . Clean the pump carefully and check for any damage after
reassembly.
Tabla de contenido
