Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Operation (Cont.)
Safety valve must
be replaced if it cannot
be actuated or it leaks air after ring is released.
3. Daily with compressor shut off: Drain
moisture from tanks by opening drain
cocks underneath end of tanks.
Drain
Cock
Figure 12
4. Turn power OFF and clean dust and dirt
from motor, tank, air lines and pump
cooling fins.
NOTE: The sponge type air filter in the
filter housing on the side of the head
must be checked and cleaned periodically,
Limited Warranty
1. DURATION: From the date of purchase by the original purchaser as follows: Standard Duty - One Year, Serious Duty - Two Years, Extreme Duty - Three Years.
2. WHO GIVES THIS WARRANTY (WARRANTOR):
Campbell Hausfeld / Scott Fetzer Company, 100 Production Drive, Harrison, Ohio, 45030, Telephone: (800) 543-6400
3. WHO RECEIVES THIS WARRANTY (PURCHASER): The original purchaser (other than for purposes of resale) of the Campbell Hausfeld compressor.
4. WHAT PRODUCTS ARE COVERED BY THIS WARRANTY: Any Campbell Hausfeld air compressor.
5. WHAT IS COVERED UNDER THIS WARRANTY: Substantial defects due to material and workmanship with the exceptions noted below.
6. WHAT IS NOT COVERED UNDER THIS WARRANTY:
A. Implied warranties, including those of merchantability and FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED FROM THE DATE OF ORIGINAL PURCHASE AS STATED IN THE DURATION.
If this compressor is used for commercial, industrial or rental purposes, the warranty will apply for ninety (90) days from the date of purchase. Four cylinder single-stage and two-stage
compressors are not limited to a ninety (90) day warranty when used in commercial or industrial applications. Some States do not allow limitations on how long an implied warranty
lasts, so the above limitations may not apply to you.
B.
ANY INCIDENTAL, INDIRECT, OR CONSEQUENTIAL LOSS, DAMAGE, OR EXPENSE THAT MAY RESULT FROM ANY DEFECT, FAILURE, OR MALFUNCTION OF THE CAMPBELL HAUSFELD
PRODUCT. Some States do not allow the exclusion or limitations of incidental or consequential damages, so the above limitation or exclusion may not apply to you.
C.
Any failure that results from an accident, purchaser's abuse, neglect or failure to operate products in accordance with instructions provided in the owner's manual(s) supplied with
compressor.
D. Pre-delivery service, i.e. assembly, oil or lubricants, and adjustment.
E.
Items or service that are normally required to maintain the product, i.e. lubricants, filters and gaskets, etc.
F.
Gasoline engines and components are expressly excluded from coverage under this limited warranty. The Purchaser must comply with the warranty given by the engine manufacturer
which is supplied with the product.
G. Additional items not covered under this warranty:
1.
All Compressors
a.
Any component damaged in shipment or any failure caused by installing or operating unit under conditions not in accordance with installation and operation guidelines or
damaged by contact with tools or surroundings.
b.
Pump or valve failure caused by rain, excessive humidity, corrosive environments or other contaminants.
c.
Cosmetic defects that do not interfere with compressor functionality.
d.
Rusted tanks, including but not limited to rust due to improper drainage or corrosive environments.
e.
Electric motors, check valves and pressure switches after the first year of ownership.
f.
Drain cocks.
g.
Damage due to incorrect voltage or improper wiring.
h.
Other items not listed but considered general wear parts.
i.
Pressure switches, air governors and safety valves modified from factory settings.
2.
Lubricated Compressors
a.
Pump wear or valve damage caused by using oil not specified.
b.
Pump wear or valve damage caused by any oil contamination or by failure to follow proper oil maintenance guidelines.
3.
Belt Drive / Direct Drive / Gas Driven Compressors
a.
Belts.
b.
Ring wear or valve damage from inadequate filter maintenance.
c.
Manually adjusted load/unload and throttle control devices.
7. RESPONSIBILITIES OF WARRANTOR UNDER THIS WARRANTY: Repair or replace, at Warrantor's option, compressor or component which is defective, has malfunctioned and/or failed to
conform within duration of the warranty period.
8. RESPONSIBILITIES OF PURCHASER UNDER THIS WARRANTY:
A. Provide dated proof of purchase and maintenance records.
B.
Portable compressors or components must be delivered or shipped to the nearest Campbell Hausfeld Authorized Service Center. Freight costs, if any, must be borne by the purchaser.
C.
Use reasonable care in the operation and maintenance of the products as described in the owner's manual(s).
9. WHEN WARRANTOR WILL PERFORM REPAIR OR REPLACEMENT UNDER THIS WARRANTY:
A. Repair or replacement will be scheduled and serviced according to the normal work flow at the servicing location, and depending on the availability of replacement parts.
B.
If the purchaser does not receive satisfactory results from the Authorized Service Center, the purchaser should contact Campbell Hausfeld (see paragraph 2).
Limited Warranty applies in the U.S. and Canada only and gives you specific legal rights. You may also have other rights which vary from State to State or country to country.
more often if used under very dusty
conditions or when a great deal of fog
from spraying is allowed to circulate near
unit.
IMPORTANT: Unit should be located as far
from spraying area as hose will allow to
prevent over-spray from clogging filter.
FILTER REMOVAL, INSPECTION AND
REPLACEMENT
To change a filter, pull off the filter
housing cover. Remove and clean the filter
in hot, soapy water. Replace a filter that
will not clean up. Place filter back in the
housing. Snap cover onto the housing.
LUbRICATION
This is an oilless type compressor requiring
no lubrication.
THERMAL OVERLOAD PROTECTOR
This compressor is
equipped with an
automatic reset thermal overload protector
which will shut off motor if it becomes
overheated.
5
WL5000 Series Contractor Models
If thermal overload protector shuts motor
OFF frequently look for the following
causes.
1. Low voltage.
2. Wrong gauge wire or length of
extension cord.
3. Clogged air filter.
4. Lack of proper ventilation.
The motor must be
allowed to cool down
before start-up is possible. The motor will
automatically restart without warning if left
plugged into electrical outlet, if the motor is
turned on.
STORAGE
1. When not in use, hose and compressor
should be stored in a cool dry place.
2. Tank should be drained of moisture.
3. Hose should be disconnected and hung
open ends down to allow any moisture
to drain.
Tabla de contenido
