Optimus Crux Manual De Instrucciones página 6

TECHNICAL SPECIFICATIONS (STOVE ONLY):
Fuel: Use only with Optimus gas cartridges in compliance
with EN417 (for Australia: 50% butane, 25% isobutane, 25%
propane) (max. 450g). IT MAY BE HAZARDOUS TO ATTEMPT
TO FIT OTHER TYPES OF GAS CONTAINERS/CARTRIDGES.
Rating: 4.2KW nominal EN521, 3.0kW gas canister EN417,
ANSI Z21.72-2016/CSA 11.2-2016: 12'000BTU/h vapour gas.
Australia: 7 Mj/h AS2658-2008 Burn Time: up to 90min at
maximum output (230g gas canister, 155g/h) Boil time: As
little as 3min depending on climate, altitude, etc. Injector size
of stove: 0.32mm EN521:2006 Category: direct pressure –
butane/isobutane/propane mix.
Australian Gas association certified. AS2658-2008
Certificate number AGA 7459 G.
1 SET UP STOVE
1. Fold out the control valve handle and make sure that the
valve is fully closed.
2. Fold out pot supports.
3. Check that o-ring between the stove and the gas cartridge
is in place and in good condition before connecting stove
to the gas cartridge.
CONNECT STOVE TO GAS
2
CANISTER
1. Hold onto the stove and screw the correct gas canister
counterclockwise tightly.
and be careful not to damage the threads when you
connect the gas canister.
2. Always keep the gas canister in an upright position while
connecting it to the stove.
3. Ensure that the stove is screwed all the way to the bottom
of the thread.
4. Make sure the stove is in a stable position so it will not tip
over.
5. Allow plenty of free space around the stove, at least 1.25m
(4ft) on each side and 1.5m (4.5ft) above it.
6. Keep stove area clear and free from combustible materials,
gasoline and other flammable vapors and liquids.
4
FIGURE [3]
FIGURE [3]
FIGURE [1]
FIGURE [4]
Tighten by hand only