Tabla de contenido
Idiomas disponibles
Idiomas disponibles
18 Series Installation - Separate Units
Jetted Shower XO™ Jet Module Trim Installation
1
A.
1
Turn off water supplies. Unscrew test
caps (1) from the body. If this is not a thin
wall mounting, the entire plasterguard may
be removed. IMPORTANT: NOTE COLOR
OF BASE ON STEM EXTENDER (2) FOR
USE LATER. (SEE CHART BELOW FOR
REFERENCE.)
C.
6
2
5
A
2
1
3
7
1
6
C
B
B.
4
Thread sleeve (1) onto brass body,
use wrench to tighten. Place the oval
escutcheon (2) over jet body module.
Thread the jet sleeve assemblies (3) onto
the jet body module. Use wrench (4) to
tighten the sleeve assemblies.
CAUTION: DO NOT OVERTIGHTEN.
TIGHTEN UNTIL THE ESCUTCHEON IS
FLAT AGAINST THE WALL.
Select proper label (1), the 3 position
4
label B (used with the blue stem
extender) or 6 position label C (used with
the black stem extender) and assemble
onto trim ring (2). (Refer to chart below
for proper label selection.) Slide trim ring
onto sleeve (3) until it bottoms out on the
escutcheon (4). Install handle (5) onto
stem, tighten set screw to secure. Thread
the bonnet assemblies (6) onto the jet
sleeve assemblies (7).
Stem
Extender
Label
4
2
3
Jetted
Jetted Shower
Shower™
XO™
2 Ports
White
Blue
A
B
1
3 Ports
Black
C
Tabla de contenido
