Using The Optional Hl760Hl760U Receiver - Spectra Precision Laser HV302 Guía De Uso

Using the optional HL760HL760U receiver

To pair the HL760/HL760U receiver with the transmitter
Make sure the transmitter is turned off.
First, turn on the receiver, then press and hold the Deadband (A) and Audio (B) buttons for two seconds.
After two seconds, the display shows MENU first, then RDIO
Press and release the Units (C) button – display shows the current radio mode.
If not already set to LS, press Units (C) button (current mode flashes) and then press Deadband (A) or
Audio button (B) until LS is displayed.
Press Units (C) button again to enter selection.
Press and release the Audio (B) button – display shows PAIR.
Press the Units (C) button again – the display shows PAIR and a rotating bar.
Then press and hold the Manual button and turn on the transmitter (Battery LED flashes fast).
After completing PAIR, OK will be displayed.
The laser pairs now automatically with the new receiver and turns back to the standard function.
Press and release the HL760/HL760U Power button two times to exit the menu at the receiver.
A laser symbol and an antenna is lit to confirm the receiver is ready for communication
with the laser.
Fingerprint function at the HL760/HL760U receiver
Fingerprinting makes sure the HL760/HL760U detects only the laser beam of the paired tarnsmitter.
Laser fingerprinting is automatically activated and confirmed with a clock symbol after a HL760/HL760U has
been paired with the laser. To recognize an ignore laser strikes from other than the paired transmitter takes
typically 5 seconds; sometimes few seconds more.
or
or
C
17
A
B