Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7b
SPRAY OPERATION
• With FAUCET on, press TOGGLE BUTTON (4) on SPRAY (3) to switch
from stream to spray.
• Press and hold PAUSE BUTTON (5) to temporarily stop flow from SPRAY
(3). Release PAUSE BUTTON (5) to resume flow from SPRAY (3).
8
SERVICE
Battery needs replacement:
• Sensor will start to blink continuously every second.
This is the indication that the batteries are low in power.
• Replace batteries in battery holder with Qty (4) AA alkaline
type batteries.
• Batteries last approximately one year.
• Always change all 4 batteries. Failure to replacing all 4
batteries at the same time may cause faucet electronics
to not work properly.
Reduced or distorted flow:
Debris or dirt accumulating at inlet or AERATOR MAY
CAUSE REDUCED OR DISTORTED FLOW.
A) Clean filter screen at inlet hoses.
B) Turn hot and cold water supply off. Open valve in mixed
position for two seconds to relief pressure close valve.
C) Disconnect inlet hoses at stop valve and clean screen
filter. If necessary remove screen filter and rinse at another
water source.
Aerator Clean Out
• AERATOR may accumulate dirt causing distored and
reduced water flow. Remove AERATOR by using the
AERATOR KEY (9) and rinse to clear any debris.
• Clean out the SCREEN (10) by removing
SPRAY HEAD (11).
Power failure (manual bypass):
• In the event of a power failure, turn the BYPASS KNOB (1)
on the SOLENOID ASSEMBLY (2) to the "ON" position.
The faucet will be in MANUAL MODE (see section 5) and
the HANDLE (2) can be used to turn on and off the water.
9
CARE:
DO: CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
3
11
9
2
- 5 -
5
STREAM (AERATOR)
4
SPRAY
3
6a
6
7
5
4
1
SCREEN FILTER
1
M965686 Rev. 1.9 (1/19)
2
Tabla de contenido
