Black+Decker MTJS1 Manual De Instrucciones página 5

Insert the saw blade into the blade clamp (11)
u
as shown. Make sure that the teeth are point-
ing to the front.
Release the lever.
u
To remove the saw blade, press the blade
u
clamp lever (12) down and pull the saw blade
from the holder.
Use
Warning! Let the tool work at its own pace. Do not
overload.
Sawing
Note: Ensure the forward reverse slider (2) is not
in the locked position.
To switch the tool on, press the variable speed
u
switch (1). The tool speed depends on how far
you press the switch.
To switch the tool off, release the variable
u
speed switch.
Hints for optimum use
Sawing
Always use the appropriate type of saw blade
u
for the workpiece material and type of cut.
If necessary, drill a hole near the starting point
u
of the cut.
All manuals and user guides at all-guides.com
(Original instructions)
u
When cutting sheet metal:
u
u
u
u
When cutting laminates:
u
u
Switch the tool on and slowly feed the saw
blade into the workpiece at the desired starting
point.
Clamp a piece of plywood or soft wood to the
back of the workpiece and saw through the
combination in order to obtain a clear cut.
Do not force the saw blade into the workpiece.
Note that cutting sheet metal will normally
take more time than sawing thicker wooden
workpieces.
Spread a thin film of oil along the cutting line
before sawing.
To cut, switch the tool on and move it down
until the saw blade is exactly over the point of
entry. Lower the rear of the shoe towards the
workpiece, maintaining a firm pivoting pressure
on the saw shoe. With the shoe flat on the
workpiece, feed the blade into the workpiece.
Cut thin laminates with the back surface facing
up, as splintering is most likely to occur on the
side of the workpiece facing the saw shoe.
For clean cuts, clamp a piece of plywood or
hardboard to both sides of the laminate and cut
through the resulting sandwich.
ENGLISH
5