Using The Feed Chute And Pushers; Using The Speed Controls - Black and Decker PERFOMANCE FP6010 Manual Del Usario

4. Attach your selected blade or disk to the center post
in the bottom of the large workbowl (instructions for
individual disks/blades follow in this manual).
5. Place the workbowl lid on top of the workbowl,
aligning the tabs and locking it into place by turning
counterclockwise. The workbowl lid is locked when
it clicks firmly into place. The lid will always and
only lock when the feed chute is aligned with the
workbowl handle. (B)
Note: Be sure to lock the workbowl in place before
attaching the blades or disks and lid.
6. Insert the large food pusher into the feed chute of
the lid. Push down until the pusher clicks into place
and rests at the bottom of the feed chute. (C)
7. Plug in the appliance. If the appliance is properly
assembled, the PULSE|OFF button will illuminate. If
it does not, the interlocks are not properly engaged.
Important: For your protection this appliance has an interlock system. The
processor will not operate unless the lid and large pusher are properly locked in
place. The unit will illuminate the PULSE|OFF light when the base, lid and large
pusher are in the proper position.
US IN G T H E F E E D C HUTE AN D PUSHERS
Note: Before operating the food processor, be sure
the workbowl, blades and workbowl lid are properly
assembled on the food processor base.
1. Insert the large food pusher into the wide mouth
feed chute. Insert the medium pusher inside the
large pusher and the small food pusher inside the
medium pusher. The food pushers are used to guide
ingredients through the feed chute. The small and
medium food pushers can be removed to add liquid
or additional foods. (D)
Note: The large pusher must remain in the feed chute in order for the processor
to operate. The unit will continue to operate if the medium or small pushers are
removed from the large pusher.
2. Place food to be processed in the opening of the large pusher. Use the
medium pusher to guide food through the large pusher and feed chute.
3. Use the small food pusher to guide food through the medium pusher.
4. Use the small food pusher as a measuring cup.
US IN G T H E S PE E D CO NTR O LS
Note: If the food processor does not run, make sure the workbowl and lid are
properly locked on the base and the large food pusher is fully in place. There is an
automatic safety lock that causes the food processor to stop working if the large
7
B
C
D