Kobalt SGY-AIR88 Manual Del Usuario página 5

REPAIR INSTRUCTIONS FOR AIR DISTRIBUTION RING
3. The new air distribution ring must be inserted in a way that the plastic
pin marked with an arrow (1) fits smoothly into the hole marked (2). (See Fig. 6)
Then firmly push in the air distribution ring. (See Fig. 7) Insert the paint nozzle and
tighten slightly. Then remove it again. Make sure the air distribution ring
fits securely against the gun body.
6
2
1
4. Mount the nozzle set:
a. Screw on paint nozzle. (See Fig. 8)
b. Attach the air cap w/ring. (See Fig. 9)
c. Put on paint needle. (See Fig. 10)
d. Attach the needle spring. (See Fig. 11)
e. Screw on the fluid adjustment knob. (See Fig. 12)
8
12
NOTE: Test spray pattern before use again.
During normal use, the air cap wings are horizontal and the air cap should be pointed up as shown here.
(See Fig. 13) This provides a vertical fan-shaped pattern which gives maximum and even material coverage
as the gun is moved back and forth parallel to the surface being finished.
13
The air cap wings
are horizontal.
7
9 10
5
11